![eKey TOCAhome Скачать руководство пользователя страница 3](http://html1.mh-extra.com/html/ekey/tocahome/tocahome_installation-and-operating-manual_2373764003.webp)
- 5 -
Device overview
2.
Device overview
Your product is set up with a finger scanner. This finger scanner reads
special characteristics of your finger lines and uses them for identification.
Each of your fingers is unique and differs from the fingers of other
persons.
Model ekey
®
TOCAhome
This model provides 1 relay.
Model ekey
®
TOCAhome 3
This model provides 3 relays. You can assign these relays to different
fingers. This can be used for example to switch a door opener, a garage
opener or an alarm device.
Model ekey
®
TOCAhome pc
Like TOCAhome 3 this model also provides 3 relays. Moreover, you can
connect the inside unit to a personal computer using a serial interface
cable.
display
connecting clamp for
power supply
4 operation
keys
sensor
clamp 3 and 4
(connection with
outside unit)
clamp 1 and 2
(connection with
outside unit)
ekey TOCA home
comes with one relay, ekey
®
TOCAhome 3 and TOCAhome
pc with three relays in order
to connect door openers etc.
status
display
marking
arrows
serial interface (only for
ekey
®
TOCAhome pc
-
6
-
180 cm
135 cm
Installation
3.
Installation
3.1.
Wall fastening of outside unit
Install the Mounting plate (as shown in the
illustration besides) directly on the wall.
The
ideal installation height is at approximately
135 cm / 52 inches (upper edge)
. At this
height the fingerprint reader is ergonomically
positioned for better reading of the finger surface
as it is being swiped.
The unit can be mounted to a standard electrical
outlet using ”In-wall mounting set“ accessory.
The mounting holes are designed to make the
assemblage on a standard electrical outlet possible. Alternatively, you can
work with pins or wooden screws or similar screws directly on the wall.
The outside unit (splash water resistant) has to be installed in a place,
where it is safe from the impact of heavy rain or snowfall as well as from
too strong an incident of solar radiation.
3.2.
Wall fastening of inside unit
Mount the “fitting plate”, which can be found at the backside of the inside
unit. The “fitting plate” at the same time serves as fastener for the casing
of the inside unit. Put up the inside unit onto the fitting plate.
Inside unit can be opened by pushing up the lock clip with a flat
screwdriver.
The inside unit has to be installed in a way that it is safe from third party
access.
Security risk!
Note:
Installation of inside unit shall be exclusively executed by qualified
personnel!