Ekahau T301W, Руководство пользователя

Страница: 19 / 36

3 Configuration After Initial Activation
The tag can be adjusted for each application and network settings by adjusting a set of parameters.
The parameters can be changed wirelessly after resetting the tag by using the Ekahau Activator
software or through
Tag Configurations in Ekahau RTLS Controller.
Ekahau Activator is used for configuring the initial configuration settings that allows connecting
the tag to ERC over the network. After connection is established with ERC, all configurations can
be managed through Ekahau RTLS Controller.
3.1 Tag Configuration Settings in ERC Configs Page
In Ekahau RTLS Controller it is possible to create a configuration to a single tag or a group config-
uration to multiple tags. After the tags are activated, the configurations are applied to tags from
the Tags page. It is also possible to apply a configuration automatically to all new tags via the
Configs page. The list of available settings is in the following table:
Values (Default underlined) Description Setting
Network
Generic (ELP), Aerohive, Aruba
blink, Cisco CCX, Motorola Allows using a vendor-specific
method for signal measurement.
The
Generic method is vendor-
independent.
Scan Method
See Configuring WLAN Set-
tings on page 6 for details
SSID 1 name, Encryption, Pass-
phrase and WEP index. SSID 1
See Configuring WLAN Set-
tings on page 6 for details
SSID 2 name, Encryption, Pass-
phrase and WEP index. SSID 2
No association and scan only;
associate and scan; Disabled Sets whether tag attempts to asso-
ciate on T301W SSID 2 network. SSID 2 Association
Enabled; Disabled Sets whether the tag uses broad-
cast probe when scanning. Broadcast probe
Tag IP Settings
Use DHCP for each access point
Use DHCP once for all access
points
Preserve the IP-address that was
given by Activator
Sets the IP method used. IP Setting
Positioning Engine
IP Address Sets the ERC IP Address. IP Address
Port number Port number of location protocol port
of ERC. Location update Port (UDP)
Port number Port number of maintenance pro-
tocol port of EPE. Maintenance port (UDP)
General
Chapter 3. Configuration After Initial
Activation
15