TECNOEKA Srl _____________________________________________________________ use and instruction manual
page 18 _________________________________________________________________________________________
-
only steam (all 10 blue leds alight /100%)
-
variable steam (blue leds 1 to 9 alight /from 10 to 90)
Set the pre-heating function (optional) pressing the push button
.
Set the motors at
½
speed function (optional) for one or more stages, pressing the push button
.
Press the push button
to start the cooking cycle.
Remember
Remember
Remember
Remember:
1.
If the cooking cycle is not controlled by the core probe and has been divided in one or
more timed stages, the oven turns off automatically when the set time for the single
stage or all the different stages together is over. If an “inF” (infinite) time has been set,
the oven continues until the operator turns it off manually pressing the push button
.
2.
If the cooking cycle is controlled by the core probe and has been divided in one or more
stages, timed if required, when the temperature set on the probe is reached it passes
onto the next stage; if it has been set for a single stage, timed if required, or for an “inF”
time, the cycle finishes and the oven turns off automatically, no matter what time was
set for the stage.
3.7.2
3.7.2
3.7.2
3.7.2 Programmed cooking
Programmed cooking
Programmed cooking
Programmed cooking
When the cooking programs have already been stored (a cooking cycle corresponds to each
program number for a specific type of food) it is very easy to use them.
Turn the oven ON (green light off) select the stored program number (shown on the program
display) using the push buttons
or
.
Press the push button
to start the cooking cycle.
At the end of the cooking cycle the oven turns of automatically and the beeper sounds for 10
seconds.
Remember
Remember
Remember
Remember: Before beginning the cooking cycle, the parameters can be checked that have
been set for the four stages (pres the push button
) and they can be changed
if wished. For the changed parameters to become operative, they must be stored
(press the push button
until the confirming beep is heard).
3.8 Black
3.8 Black
3.8 Black
3.8 Black----out
out
out
out
When the power supply returns after a black-out, the oven will continue working counting the
remaining time for the cooking cycle after the interruption.
3.9
3.9
3.9
3.9 Communications with PC
Communications with PC
Communications with PC
Communications with PC
At the bottom of the control panel (seen from below) there is an inlet (remove the rubber
protection) for a serial gate for interactive communications with a PC.
If this gate is connected to a PC with wineka software
wineka software
wineka software
wineka software (optional), up to 99 preset cooking
programs can be transmitted to the oven memory for all the operating parameters; likewise, the
cooking programs that are already stored in the oven memory can be acquired by the PC.
Certain operational parameters for the oven can also be changed.
