EK-Quantum Velocity 2 D-RGB AM4, Руководство пользователя

Страница: 14 / 16

- 14 -
STEP 5
STEP 5
With EK-Velocity² series water blocks, it is mandatory to use the
bottom port as the
INLET . Mixing the ports may result in poor
thermal performance of the water block.
Tighten the fittings in clockwise direction until the gasket underneath
is compressed.
The installation of the Velocity² water block is now complete.
OUTLET
INLET
STEP 4
After placing the water block, the stored backplate must be attached
on the backside of the motherboard using Allen Key 2.5 mm (shown
in the picture).
Start fastening the backplate, preferably in a cross pattern. Do not
tighten fully until all of the nuts are partially screwed in. The Allen
Key 2.5mm must be used in a standing position! Otherwise, the
mounting screws may crack during tightening!
EK recommends using the EK-Loop Torque Screwdriver - 0.6Nm :
https://www.ekwb.com/shop/ek-loop-torque-screwdriver-0-6nm
Make sure to orientate the backplate as illustrated.
Incorrect installation of the backplate may result in
damage to the motherboard.
STEP 4
1
2
4
3
TOP OF THE
MOTHERBOARD
MAX TORQUE:
0.6 Nm