- 19 -
FITTINGS AND TUBING
STEP 1
Screw-in two (2) G1/4 threaded male fittings. Attach the liquid-
cooling tubes and connect the water block to the cooling loop.
Tighten the fittings in a clockwise direction until the gasket
underneath is compressed.
EK recommends using EK fittings with all EK water blocks.
Do not forget to plug the remaining two openings with
enclosed EK-Plug G1/4 or its equivalent.
CAUTION: When using connectors other than EK fittings,
pay special attention to the length of the fittings’ male G1/4”
thread – 5 mm is the maximum G1/4” thread length allowed!
STEP 1
TUBING
IN
OUT
EK-FITTING
For this step, you will need:
The installation of the water block is now complete.
EK-Loop Multi Allen Key
