- 14 -
STEP 2
Put two (2) O-rings 14 x 1 into slots on the cold plate. Then carefully
place the active backplate on standoffs as shown in the image. While
putting the active backplate on the PCB, make sure the O-rings stay
in the slots.
Before attaching the Active Backplate, make sure all the
Thermal Pads are placed correctly!
STEP 2
For this step, you will need:
Phillips Head Screwdriver
O-RING
14 x 1 mm
Allen Key 2.5mm
ACTIVE
BACKPLATE
STEP 3
Place ten (10) M3 x 10 AX1 screws into the water block standoffs and
tighten them using Philips head screwdriver (as shown in the image).
After attaching the AX1 Screws, three (3) terminal screws M4 x 20
DIN7984 need to be attached using Allen Key 2.5mm. The terminal
badge can be reused, after securing the terminal screws.
STEP 3
TERMINAL
BADGE
M4 x 20 DIN7984
SCREW
M3 x 10 AX1 SCREW
