- 11 -
CONNECTING THE D-RGB LED STRIP
STEP 1
D-RGB HEADER
D-RGB LEDs PCB
JET PLATE
SEALING GASKET
RGB HEADER
STEP 1
Plug the 3-pin D-RGB connector from your CPU water block to the
D-RGB header on your motherboard or controller. The LED strip will
work only if the pin layout on the header is as follows:
+5V, Data,
Empty, Ground
.
Incorrect installation or installation to the incorrect header
may result in damage to the LED strip or the header itself!
REPLACING THE D-RGB LEDs
SCREW M4x14 DIN 7991
Use the Allen key to unscrew four (4) M4 x 14 screws from the bottom
of the water block.
Carefully disassemble the block and replace the LED’s PCB unit.
Make sure the Jet plate and the O-ring are well aligned when you put
everything back together.
