Eizo RadiForce MX191, Инструкция по эксплуатации

Страница: 8 / 28

No-Picture Problem
If no picture is displayed on the monitor even after the following remedial action is taken, contact your local
dealer.
1. Check the Power indicator.
Symptom Status Possible cause and remedy
No picture
Power indicator does not light
up.
• Check whether the power cord is connected
correctly. If the problem persists, turn off the
monitor, and then turn it on again a few minutes
later.
•
Press .
Power indicator lights blue. •
Set each adjusting value in [Brightness],
[Contrast] and [Gain] to higher level.
Power indicator lights orange.
•
Switch the input signal with .
• Press a key on the keyboard or click the mouse.
• Check whether the PC is turned on.
2. Check the error message that remains on the screen.
These messages appear when the input signal is incorrect even if the monitor is functioning.
Symptom Status Possible cause and remedy
The input signal is not
received.
•
The message shown left may appear, because
some PCs do not output the signal soon after
power-on.
•
Check whether the PC is turned on.
•
Check whether the signal cable is properly
connected to the PC.
•
Switch the input signal with .
The message shows that the
input signal is out of the
specified frequency range.
(Such signal frequency is
displayed in yellow.)
•
Check whether the signal setting of your PC
matches to the resolution and the vertical
frequency settings for the monitor. (See
“Compatible Resolutions/Frequencies” on the
cover back.)
•
Reboot the PC.
•
Change the mode to an appropriate mode using
the graphics board’s utility software. Refer to the
manual of the graphics board for details.
fD: Dot Clock
(Displayed only when the digital signal inputs)
fH: Horizontal Frequency
fV: Vertical Frequency
6