Eizo DuraVision FDS1904, Руководство по установке

Страница: 23 / 72

3
En
gli
sh
WARNING
Use the unit in an appropriate location.
Not doing so may result in fire, electric shock, or equipment damage.
• Do not place outdoors.
• Do not place in a location where it may be affected by strong vibration or shocks.
• Do not place in a dusty or humid environment.
• Do not place in a location where water is splashed on the screen (bathroom, kitchen, etc.).
• Do not place in a location where the steam comes directly on the screen.
• Do not place near heat generating devices or a humidifier
• Do not place in a location where the product is subject to direct sunlight.
• Do not place in an inflammable gas environment.
Install the monitor so that users are unable to touch the power input terminal on the rear
of the monitor.
Touching the power input terminal may result in electric shock.
Apply insulation protection to the power input terminal according to the applicable standards for
finished products after enclosure installation.
Use the unit within the rated voltage range.
Not doing so may result in fire, electric shock, or equipment damage.
Power supply: AC AC 100-240 V, 50/60Hz
DC DC +24 V
If using the AC power connector, make sure the power cord meets the following require-
ments.
This product does not include a power cord. Please prepare separately a power cord which
meets the requirements.
* The power cord must be compliance with the mandatory standards of the country and region
in which this product is to be used.
- For Europe: The power cord set has rated value of at least AC 250V~ 10A and has cord type
H05VV-F, GTCE-3, 0.75mm 2 .
- For USA: The power cord set has rated value of at least AC 125V~ 10A and has cord type SVT,
3/18AWG (0.75mm
2
).
- For Japan The power cord set has rated value of at least AC 125V~ 7A and has cord type VCTF,
0.75mm
2
.
- For China: The power cord set has rated value of at least AC 250V~ 10A and has cord type “ 配
60227 IEC53 3×1 平方毫米 ”
The equipment must be connected to a grounded main outlet.
Failure to do so may result in fire or electric shock.
If using the DC power terminal block, connect it securely.
Accidental disconnection of the terminal may result in fire, electric shock, or equipment damage.
Use the correct voltage.
• The unit is designed for use with a specific voltage only. Connection to polarities and voltages
other than those specified on the monitor or in this User’s Manual may cause fire, electric
shock, or equipment damage.
• Do not overload your power circuit, as this may result in fire or electric shock.
Only supply power after completing all power connections.
Making connections with power supplied may result in electric shock.
If using the DC power terminal block, do not touch the terminal block while it is electri-
fied.
Touching the terminal block in this state may result in electric shock.