EIT Part Number: P/N IM-0110 Rev A Issued April 2019
Page 7
Operation:
Top:
DataReader program version
Middle:
Reset “r” number
Bottom:
Optics side of MicroCure
which needs to be exposed to UV
1. Insert the MicroCure radiometer into the slot in the upper left side
of the DataReader.
2. Press the RESET button to activate the unit from standby/sleep
mode and turn the unit on to active data collection mode.
3. The DataReader will briefly display the software version (e.g.,
P1.02 or similar)
4. The number of readings taken by the MicroCure is displayed as "r
xxx" where "xxx" is the number of unit resets. Then the display will
read "0.00" to indicate that the unit is ready to take a reading.
5. Remove the MicroCure from the DataReader and place it in the
desired UV process location with the optics window side facing the
UV source(s).
6. The MicroCure
radiometer must be exposed to UV energy within
four minutes after being reset or it will return to a standby/sleep
mode. The UV irradiance level be above the start threshold level
as described in Appendix A.
7. The MicroCure
®
it will return to standby/sleep mode if the start
threshold is not exceeded. Only runs above threshold are counted
towards the limits of 200 readings. The DataReader will
automatically shut down after thirty seconds of inactivity.
8. Remove the MicroCure
from the UV process environment and
place it back into the slot in the DataReader. Press the SELECT
button. The DataReader will display the total UV energy in Joules
per square centimeter (J/cm²) or the irradiance in Watts per
square centimeter (W/cm²).
9. To toggle between total energy and irradiance, press and hold the
SELECT button
10. To clear the current reading and to reset the MicroCure for its
next reading, press the RESET button.