eisenblatter MINI MAX 1100, Оригинальное руководство пользователя

Страница: 20 / 28

www.eisenblaetter.de
20
Original instructions MINI MAX
®
1100 / MINI MAX
®
AKKU
EN
5.5 Safety warnings specific for wire brushing
operations:
• Be aware that wire bristles are thrown by the
brush even during ordinary operation. Do not
overstress the wires by applying excessive load to
the brush.
The wire bristles can easily penetrate light
clothing and/or skin.
• If the use of a guard is recommended for wire
brushing, do not allow any interference of the
wire wheel or brush with the guard. Wire wheel or
brush may expand in diameter due to work load and
centrifugal forces.
5.6 Additional safety instructions:
WARNING – Wear protective gloves.
WARNING
– Wear hearing protection.
Exposure to noise can cause hearing loss.
WARNING
– Always wear safety glasses.
• Observe the specifications of the tool or accessory
manufacturer!
• Accessories must be stored and handled with care in
accordance with the manufacturer‘s instructions.
• Ensure that accessories are installed in accordance
with the manufacturer‘s instructions.
• Never place your hand near rotating parts of the
device or near the rotating sanding belt.
• Remove sanding dust and similar material only when
the machine is not in operation.
• The tool continues running after the machine has
been switched off.
• The workpiece must lay flat and be secured against
slipping, e.g. using clamps. Large workpieces must be
sufficiently supported.
• Damaged, eccentric or vibrating tools must not be
used.
• Avoid damage to gas or water pipes, electrical lines
and load-bearing walls (statics).
• A damaged or cracked side handle must be replaced.
Never operate a machine with a defective side handle.
• Always guide the machine with both hands on the
handles provided.
• Attach small workpieces. For example, clamp in a vice.
5.7 Special safety instructions for mains powered
machines:
• Pull the plug out of the socket before making
any adjustments, changing tools, carrying out
maintenance or cleaning.
• Before connecting the mains plug, make sure that the
machine is switched off.
• Use of a fixed extractor system is recommended.
• Always install an RCD with a maximum trip current of
30 mA upstream. If the power tool is shut down via the
RCD, it must be checked and cleaned. See chapter 13.
Maintenance.
5.8 Special safety instructions for cordless
machines:
• Remove the battery pack from the machine before
making any adjustments, changing tools, maintaining
or cleaning.
• Make sure that the tool is switched off before fitting
the battery pack.
Protect battery packs from water and moisture!
Do not expose battery packs to naked flame!
• Do not use faulty or deformed battery packs!
• Do not open battery packs!
• Do not touch or short circuit battery pack contacts!
A slightly acidic, flammable fluid may leak from
defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately with
plenty of water. If battery fluid leaks out and
comes into contact with your eyes, wash them with clean
water and seek medical attention immediately!
• If the machine is defective, remove the battery pack
from the machine.
Transport of Li-ion battery packs:
The shipping of Li-ion battery pack is subject to laws
related to the carriage of hazardous goods (UN 3480
and UN 3481). Inform yourself of the currently valid
specifications when shipping Li-ion battery packs. If
necessary, consult your freight forwarder.
Only send the battery pack if the housing is intact and
no fluid is leaking. Remove the battery pack from the
machine for sending. Prevent the contacts from short-
circuiting (e.g. by protecting them with adhesive tape).