Eisen HT3300, Инструкция по эксплуатации, Страница: 5 / 6

5
REF NO. PARTS DESCRIPTION QTY.
1 ø18, C ring 2
2 ø18 Washer 2
3 Front Wheel 2
4 Left Shaft unit 1
5 Rod Link 2
6 SPINDLE 2
7 Right Shaft unit 1
8 LIFT ARM 1
9 ø16, C ring 2
10 Saddle 1
11 ø25, C ring 2
12 Return Spring 2
13 ø4x45 Coder Pin 1
14 Reinforce Axle 1
15 Reinforce Axle-Rod 2
16 ø8, lock washer 6
17 M8x20 Inner Hex Bolt 6
18 ø16, lock washer 4
19 ø16, Nut 2
20 ø16, thin Nut 2
21 Pin Link Rod 2
REF NO. PARTS DESCRIPTION QTY.
22 Screws M5*15 4
23 Pull-Rod 2
24 Safety Head 2
25 Cover 1
26 Power unit 1
27 M12 Handle Bolt 1
28 Handle Socket 1
29 Roller 1
30 ø25x18 Coder Pin 1
31 Plunger Pin 1
32 ø18 lock washer 2
33 M18 Short Bolt 2
34 Rear Wheel 2
35 "M10x20 Inner Hex Bolt" 4
36 ø10 lock washer 4
37 Handle Assemble 1
38 M6x35 Handle Bolt 1
39 Saddle Axle 1
40 Saddle pad 1
41 Handle Foam 1
42 Oil Filler Plug 1
PART LIST
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Jack will not lift the load. 1. Release valve not tightly closed.
2. Low oil level.
3. Defective or worn internal parts.
4. Load exceeds maximum
allowance.
1. Tighten release valve.
2. Check and add oil. Follow “Check and Refill Oil” instructions
on Page 3.
3. Discontinue use and contact a TH authorized repair center.
4. Use a higher capacity jack.
Jack will not hold the load. 1. Release valve not tightly closed.
2. Power unit malfunction.
1. Tighten release valve.
2. Discontinue use and contact a TH authorized repair center.
Jack will not descend to
minimum height, or will
not remain in lowered
position. 1. Air trapped in system.
2. Reservoir oil overfilled.
1. Vent air out of system. Follow “Air Venting Procedures” above.
2. Check and ensure proper oil level. Follow “Check and Refill
Oil” instruction on Pg.3.
Jack will not lift to max
height. 1. Low oil level. 1. Check and ensure proper oil level. Follow “Check and Refill
Oil” instructions above.
Jack will not function
properly after tried
solution. 1. Internal malfunction or structural
damage.
1. Stop usage and contact a TH authorized repair center.
TROUBLE SHOOTING
DISPOSAL
The components or the used product must be given to companies that specialize in the disposal and
recycling of industrial waste.