Page 2 of 12
Drawing : - TPC478
Issue
: - 5
Date
: - 11/04/19
INTRODUCTION
Designed for a wide range of applications, the RM75 DV is a rugged,
industrial unit, which utilizes an energy-efficient compressor and a compact
portable design to provide easy efficient drying.
The fan draws the moist air through the cold evaporator coil, which cools the
air below its dew point. Moisture forms on the evaporator coil and is collected
in the condensate tray, which is equipped with a permanent drain. The cooled
air then passes through the hot condenser coil where it is reheated using the
same energy removed during the cooling phase, plus the additional heat
generated by the compressor. The air is, therefore, discharged from the
dehumidifier at a slightly higher temperature with a lower absolute humidity
than that which entered. Continuous circulation of air through the
dehumidifier gradually reduces the relative humidity within the area.
The RM75DV dehumidifier is a rugged, reliable drying unit designed to
operate effectively over a broad range of temperature and humidity
conditions. An active hot gas defrost system, controlled by an electronic
timer, guarantees positive de-icing, thereby optimizing operation at low
temperatures.
The RM75 DV unit is fitted with a transformer which will allow the unit to
operate on either 110volts or 230volts 1ph 50hz power supply. This unit is
fitted with a screw type in line fuse holder with a 5amp anti surge fuse. All
electrical components within the dehumidifier are rated for 110volts, for safety
reasons. The Voltage change over (selector switch) switch, can be found
through the front air off grille
The unit incorporates a rotational moulded polyethylene shell resilient to
damage caused by rough handling.