Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (1-3)
1 Sawing
table
2
Saw blade guard
3 Push
stick
4 Saw
blade
5 Splitter
6 Table
insert
7 Parallel
stop
8 Hand
crank
9 Eccentric
lever
10 Additional table
11 Switch/plug block
12 Scale
13 Extractor hose
14 100 mm diameter extractor connection
15 Chassis
16 Push handles
17 Guide for parallel stop
18 Legs
19 Mounting for slide rail
20 Slide rail
21 Mounting for extractor hose
22 Mounting for wheels
23 Stop rail
24 Struts
25 Rubber feet
28 Setting screw and locking screw
3. Items supplied (Fig. 1-4)
Bench circular saw
Carbide-tipped saw blade
Slide
Parallel stop
Push stick
Additional table
Tools
Chassis
Installation material
4. Proper use
The bench-type circular saw is designed for the
slitting and cross-cutting (only with the cross stop) of
all types of timber, commensurate with the machine’s
size. The machine is
not
to be used for cutting any
type of round wood.
The machine is to be used only for its prescribed
purpose.
Any other use is deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that
result from such misuse. The machine is to be
operated only with suitable saw blades (saw blades
made of HM or CV) It is prohibited to use any type of
HSS saw blade and cutting-off wheel. To use the
machine properly you must also observe the safety
regulations, the assembly instructions and the
operating instructions to be found in this manual.
All persons who use and service the equipment have
to be acquainted with this manual and must be
informed about the machine’s potential hazards. It is
also imperative to observe the accident prevention
regulations in force in your area. The same applies
for the general rules of health and safety at work.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine’s construction and
design:
Contact with the saw blade in the uncovered
saw zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of work-
pieces.
GB
18
Anleitung_RT_TS_2231_UD_SPK1:_ 11.03.2009 12:53 Uhr Seite 18
