EINHELL RG-EC 2240MG, Оригинальная инструкция по эксплуатации

Страница: 23 / 132

앬 Whenever possible, use the claw stop as a
leverage point.
Cutting wood which is under tension
Special care is required when cutting wood which is
under tension. Wood which is under tension from
which it is released by cutting may in some cases
react completely unpredictably and uncontrollably. In
the worst case this could result in extremely severe or
even fatal injuries (Fig. 22-24).
This type of work must only be performed by persons
who have been specially trained.
7. Technical data
Mains voltage: 230 V ~ 50 Hz
Power rating: 2200 W
Idling speed: 7500 min -1
Cutter rail length: 400 mm
Cutting length, max.: 375 mm
Cutting speed at rated rpm: 16 m/s
Oil tank capacity: 200 ml
Weight with cutter rail and chain: 5.3 kg
Protection class: II /
쏾
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level 94,4 dB(A)
K
pA
uncertainty 3 dB
L
WA
sound power level 107 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Front Handle under load
Vibration emission value a
h
= 5.343 m/s 2
K uncertainty = 1.5 m/s 2
Rear Handle under load
Vibration emission value a
h
= 4.942 m/s 2
K uncertainty = 1.5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
8. Maintenance
8.1 Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if
앬 the guide groove of the cutter rail is worn;
앬 the nose sprocket in the cutter rail is damaged or
worn.
Proceed as described in the section “Assembly of the
cutter rail and the saw chain”.
GB
23
Anleitung_RG_EC_2240_MG_SPK7:_ 17.02.2011 14:50 Uhr Seite 23