EINHELL BT-GW 150, Оригинальная инструкция по эксплуатации, Страница: 19 / 112

19
GB
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be found in
the enclosed booklet.
2. Layout and items supplied (Fig. 1-8)
1. Handle
2. Operating status indicator
3. Thermostat control lamp
4. Housing
cover
5. Gas bottle support surface
6. Castors
7. ON/OFF/Welding current switch
8. Supporting
foot
9. Mains plug
10. Earth terminal
11. Hose package
12. Gas nozzle
13. Burner
14. Welding wire speed controller
15. Belt strap
16. Gas supply connector
17. Welding screen
18. Shielding gas hose
19. Pressure reducer
20. Pressure gauge
21. Screw connector
22. Safety valve
23. Shielding gas hose connector
24. Rotary knob
25. Burner switch
26. 2 x contact pipe
2.1 Assembly material
a. 8 x Screw for castors
b. 8 x Spring ring for castors
c. 8 x Washer for castors
d. 4 x Screw for handle
e. 4 x Spring ring for handle
f.
4 x Washer for handle
g. 2 x Screw for supporting foot
h. 2 x Spring ring for supporting foot
i.
2 x Washer for supporting foot
j. 2 x Hose clip
k. 1 x Safety glass frame
l.
1 x Welding glass
m. 1 x Transparent safety glass
n. 2 x Safety glass retaining bushes
o. 3 x Nut for handle
p. 3 x Screws for handle
q. 2 x Safety glass retaining pin
r.
1 x Handle
s. 1 x Welding screen frame
3. Intended use
The shielding gas welding set is exclusively designed
for welding steel with the MAG (Metal Active Gas)
method using the appropriate welding wires and
gases.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Important information about the power
connection
This equipment falls under Class A of the standard
EN 60974-10, i.e. it is not designed for use in
residential areas in which the power supply is based
on a public low-voltage supply system because given
unfavorable conditions in the power supply the
equipment may cause interference. If you want to use
the equipment in residential areas in the which the
power supply is based on a public low-voltage supply
system, you must use an electromagnetic filter which
reduces the electromagnetic interference to the point
where the user no longer notices any disturbance.
In industrial parks or other areas in which the power
supply is not based on a public low-voltage supply
system the equipment can be used without such a
filter
.
Anleitung_BT_GW_150_SPK1__ 23.01.13 07:26 Seite 19