
GB
GB
- 39 -
11. Service information
We have competent service partners in all coun-
tries named on the guarantee certificate whose
contact details can also be found on the guaran-
tee certificate. These partners will help you with
all service requests such as repairs, spare and
wearing part orders or the purchase of
consumables.
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use
as consumables.
Cordless Hammer Screwdriver
Category
Parts
Wear parts*
Drill chuck/Battery
Consumables*
Bits inserts/Drill bits
* Not necessarily included in the scope of deli-
very!
In the effect of defects or faults, please inform the
problem to the contact address indicated at the
warranty card of your country. Please
ensure that you provide a precise description of
the problem and answer the following questions
in all cases:
•
Did the equipment work at all or was it defec-
tive from the beginning?
•
Did you notice anything (symptom or defect)
prior to the failure?
•
What malfunction does the equipment have in
your opinion (main symptom)?
•
Describe this malfunction.
10. Charger indicator
Indicator status
Explanations and actions
Red LED
Green LED
Off
Flashing
Ready for use
The charger is connected to the mains and is ready for use; there is no
battery pack in the charger
On
Off
Charging
The charger is charging the battery pack in quick charge mode.
Off
On
The battery is 85% charged and ready for use.
(Charging time for 1.5 Ah battery: 30 min)
(Charging time for 2.0 Ah battery: 40 min)
(Charging time for 3.0 Ah battery: 60 min)
(Charging time for 4.0 Ah battery: 80 min)
(Charging time for 5.2 Ah battery: 130 min)
The unit then changes over to gentle charging mode until the battery is
fully charged.
(Total charging time for 1.5 Ah battery: approx. 40 min)
(Total charging time for 2.0 Ah battery: approx. 50 min)
(Total charging time for 3.0 Ah battery: approx. 75 min)
(Total charging time for 4.0 Ah battery: approx. 100 min)
(Total charging time for 5.2 Ah battery: approx. 140 min)
Action:
Take the battery pack out of the charger. Disconnect the charger from
the mains supply.
Flashing
Off
Adapted charging
The charger is in gentle charging mode.
For safety reasons the charging is performed less quickly and takes
more than 1 hour. The reasons can be:
- The battery pack has not been used for a very long time or an already
flat battery was further discharged (exhaustive discharge).
- The battery pack temperature is outside the ideal range (between 25°
C and 45° C).
Action:
Wait for the charging to be completed; you can still continue to charge
the battery pack.
Flashing
Flashing
Fault
Charging is no longer possible. The battery pack is defective.
Action:
Never charge a defective battery pack.
Take the battery pack out of the charger.
On
On
Temperature fault
The battery pack is too hot (e.g. due to direct sunshine) or too cold
(below 0° C).
Action:
Remove the battery pack and keep it at room temperature (approx. 20°
C) for one day .
Anl_SA_TE_CI_18_Li_BL_Solo.indb 39
Anl_SA_TE_CI_18_Li_BL_Solo.indb 39
09.02.2021 14:07:29
09.02.2021 14:07:29