EINHELL 45.139.50, Оригинальная инструкция по эксплуатации, Страница: 20 / 170

GB
- 20 -
In switch position C the chisel is not locked.
•
For chiseling, press the button (h) on the
rotary switch (2) and simultaneously turn the
rotary switch (2) to position D.
The chisel is locked in position D.
Important!
You need apply only slight contact pressure for
impact drilling. Excessive contact pressure will
place unnecessary strain on the motor. Check drill
bits at regular intervals. Sharpen or replace blunt
drill bits.
6.2 Changeover switch (Fig. 9)
Using the changeover switch (3) above the On/
O ff switch (4) you can select the direction of rota-
tion of the equipment and lock the equipment so
that it cannot be switched on accidentally. You can
select between clockwise and counter-clockwise
rotation. To avoid causing damage to the gearing,
the direction of rotation must only be changed
when the equipment is at a standstill. When the
changeover switch (3) is in the middle position,
the On/O ff switch (4) is blocked.
Danger!
To avoid danger, the machine must only be held
using the two handles.
Otherwise you may su ff er an electric shock if you
drill into electric cables!
6.3 On/O ff switch (Fig. 9)
In fi nitely variable speed control is possible with
the On/O ff switch (4). The further you push the
switch, the higher the speed of the equipment.
Switching on:
Press the On/O ff switch (4).
Switching o ff :
Release the On/O ff switch (4).
6.4 LED light (Fig. 1)
The LED light (5) can be used in poor lighting
conditions to illuminate the area where you want
to drill or screw. The LED light (5) will come on
automatically as soon as you press the On/O ff
switch (4).
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from !
www.kwb.eu
welcome@kwb.eu
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
Anl_Herocco_36_28_SPK9.indb 20 Anl_Herocco_36_28_SPK9.indb 20 06.07.2020 13:51:49 06.07.2020 13:51:49