EINHELL 43.406.80, Руководство по эксплуатации

Страница: 21 / 80

saw!
Replace a worn or damaged push stick
immediately.
9.1.3. Cutting extremely narrow workpieces (Fig.
27)
Be sure to use a push block (d) when making
longitudinal cuts in very narrow workpieces with
a width of 30 mm and less.
The low guide face of the parallel stop is best
used in this case (see Fig. 23).
There is no push block supplied with the
saw! (Available from your specialist dealer)
Replace the push block without delay when it
becomes worn.
9.1.4. Making concealed cuts (Fig. 28)
Concealed cuts and groove cuts are possible thanks
to the removable saw blade guard and the infinitely
adjustable cutting height of 0-83mm.
Remove the blade guard (2) (see 7.4).
Set the splitter (5) for concealed cuts (see 7.5.2.)
Set the desired cutting depth (Fig. 8.2)
Mount the parallel stop (7) to the right of the
blade and set the desired width (8.3)
Push the workpiece into the blade (4). Make
sure that the workpiece lies solidly on the saw
table (1).
Select the cutting sequence so that the cut strips
fall away on the left side of the blade and
jamming between the stop and the blade is
prevented (risk of kick-back).
After you have finished cutting, refit the blade
guard (2)
immediately .
9.1.5. Making bevel cuts (Fig. 29)
Bevel cuts must always be used using the parallel
stop (7).
Set the blade (4) to the desired angle. (See 8.5.)
Set the parallel stop (7) in accordance with the
workpiece width and height (see 8.3.1)
Carry out the cut in accordance with the
workpiece width (see 9.1.2 and 9.1.3.)
9.2. Working with the sliding table
9.2.1 Making cross cuts (Fig. 26, 27)
Pull the sliding table (3) forward.
Set the cross stop (7) to the required angle
dimension and clamp it in place on the sliding
table (3).
Press the workpiece firmly against the cross stop
(7) and push the sliding table slowly toward the
blade (27).
Always push the sliding table (3) forward to the
point where the workpiece is cut all the way
through.
Switch off the saw again. Important: Do not
remove the offcut until the blade (4) has stopped
rotating.
9.2.1 Making edging cuts with the sliding table
(28)
Pull the sliding table (3) forward.
Place the workpiece on the sliding table and
press it firmly against the edging plate (c)
Push the sliding table (3) with the workpiece
toward the blade and make the cut.
10.0. Maintenance
Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.
11.0. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
21
Anl FKS 22-315 D SPK1 22.09.2005 15:21 Uhr Seite 21