6
Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
Use
The drill is designed for drilling holes into wood, iron,
non-ferrous metals and rock using the appropriate
bits.
Description (Fig. 1)
1
drill chuck
2
Depth stop
3
Additional handle
4
Selector button: drill/hammer
5
Selector button:
clockwise/anticlockwise
6
Speed control
7
Locking button
8
On/Off switch
On/Off switch (Fig. 1):
To switch on:
Press switch 8
Continuous operation:
Lock switch 8 with locking
button 7
To switch off:
Press switch 8 briefly
The speed is varied by applying more or less
pressure on switch 8. You can preselect the speed
by turning the knurled screw in switch 8.
Selector button: drill/hammer (Fig. 2/3)
Please note:
This switch should be
in ‘drill’ position when drilling holes in tiles.
Position A:
Rotary switch in “Hammer drill”
position.
Change switch position
only when the drill is at a standstill!
Position B:
Rotary switch in “Drill” position.
Change switch position only when
the drill is at a standstill!
Technical data
Voltage:
230 V ~ 50 Hz
Power rating:
1050 W
Drilling capacity
Concrete 13 mm
Steel 13 mm
Wood 32 mm
No Load Speed
0 - 3000 min
-1
Safety insulated
II /
쓑
Sound pressure level L
pA
98 dB(A)
Sound power level L
WA
109 dB(A)
Vibration a
hv
12,8 m/s
2
Weight
2,4 kg
Caution
앬
The BSM 1000 is not designed for the operating
of auxiliary devices.
앬
Do not use near steams or inflammable liquids.
앬
Only use sharp bits and suitable screwing bits.
앬
Remove the plug from the socket for all adjusting
and cleaning work.
앬
Protect the mains cable against any damage. Oil
and acids can damage the cable.
앬
Do not carry the device by the mains cable.
앬
Do not remove the plug from the socket by
pulling the mains cable.
앬
Make sure before inserting the plug that the
operating switch is not locked.
앬
When using a cable drum uncoil the cable
completely. Cross-section of wire at least 1,5
mm
2
.
앬
Do not overload machine.
앬
Secure all workpieces to be processed
sufficiently.
앬
Do not allow children to have access.
앬
Make sure you have a secure stance on ladders
or scaffold-ing when using the drill freehand.
앬
Localise lines with a line detector in walls where
power, water or gas lines are laid invisibly.
앬
Wear protection goggles and use a dust mask for
dust-producing work.
앬
Always arrange for a qualified electrician to carry
out repairs
앬
Use only original replacement parts
앬
The level of noise at the workplace may exceed
85 dB(A). In this case you will need to introduce
noise protection measures for the user. The
GB
Anl BSM 1000_SPK1 07.09.2006 10:39 Uhr Seite 6
