Eiki EK-355U, Руководство пользователя

Страница: 29 / 87

29
Power off the projector
Power
Power
1. Press the Power button at the control panel
or the remote controller, the “Power off?”
message displays.
2. Press the Power button again in 4 seconds
after the “Power off?” message prompted
to you. The POWER indicator flashes red
while the cooling fan continues running.
(You may set up noise level and speed of
the fan.) Unplug the power cord until the fan
stops running. Failure to do so may shorten
life cycle of the projector or lead to power
on failures or operation abnormalities.
3. The POWER indicator stops flashing once
the projector has been cooled down to
ready for power on again.
Do not use the projector without stop.
As it may hurt the life cycle of the
LED light source. Power off the pro-
jector at least once every 24 hours
and have it idle for an hour.
Power off?
“Power off?” message disappears
in 4 seconds.
Note:
● If the “On Start” function is set to “On”, the projector will power on once it is connected to an
AC power socket. (Refer to page 43)
● Speed of the cooling fan varies with internal temperature of the projector.
● Do not place the projector in any box before it is fully cooled down.
● In case the STATUS indicator flashes or turns red, refer to the “Light indicator status” for
instructions. (Refer to page 77)
● The POWER indicator flashes when the LED light source is cooling down. Do not power on
the projector at this time. Power on the projector only after the POWER indicator turns red.
● Unplug the power cord after the projector has been turned off. The fan stops running.
● The POWER indicator turns red when the projector is ready for power on again.
Basic operation