Eightpins NGS2, Руководство по установке и инструкция

Страница: 29 / 36

29
EIGHT PINS
Reinstall the cartridge
Hook the end cap of the outer cable into the counterpart of
the mounting interface of the seat post. Use both thumbs
to push down the release slider and hold it fi rmly with one
thumb.
Achtung! Before further installation, ensure that the cable is guided centrally in the longitudinal guide. If this is
next to it, it will be clamped by the pipe.
Insert the cartridge until you can see the Postpin mounting interface through the hole of the Postpin frame interface.
You must be able to fully see the slot of the mounting interface through the hole. Insert the Postpin axle into the post-
pin hole of the postpin interface and tighten it loosely with a 5mm hex key.
Hook the cable with the
nipple into the holder in the
release slider.
Carefully insert the cartridge into the seat tube. Pull the
cable housing out of the frame to assist.
Never pull the cable to
much forward at an angle.
This can damage the relea-
se slider.