Eightpins NGS2, Руководство по установке и инструкция

Страница: 17 / 36

17
EIGHT PINS
Mounting the saddle
Attention: The back screw of the seat post head must not be tightened with more than
8 Nm, as it might break and lead to an increased risk of injury.
Loosen and remove the
rear screw of the saddle
clamp.
With the front screw, adjust the saddle angle. Turning it clockwise, the tip
of the saddle moves upwards; turning it anticlockwise, the tip of the saddle
moves downwards.
With an 5mm bit and a torque wrench, tighten the rear screw with 8 Nm.
Note: Altering the saddle angle, you always need to loosen the
rear screw fi rst.
With the saddle angle ad-
justment screw, loosen the
front screw.
Insert the top saddle plate
and position it over the
saddle rails.
Have the saddle lay on
the sockets for the saddle
rails and insert the back
screw for the saddle fi xation
again.
ATTENTION: The nuts
which are installed
in the top seatclamp
have two small fl at
areas which have to
be aligned in the long
hole parallel to the
riding direction.
ATTENTION: If the nut
are not aligned cor-
rectly and the screws
get tightened, the nuts
getdamaged and can´t
move anymore. This
can cause a crack of
the screws. High risk
of injury!