8
1
-800-497-4524 EIC SOLUTIONS, INC
.
215-443-5190
3.
Using the 8-32 keps nut provided, attach the drip pan to the air conditioner.
4.
Attach the supplied PVC drain tube to the hose fitting on the drip pan. This tube should be
routed to the bottom of the enclosure and fed through a 3/8” hole to the outside.
5.
If you purchased a horizontal drip pan, it is installed at the factory and you will only need to
install the hose fitting and PVC drain hose.
YOU MUST USE THE FACTORY INSTALLED HORIZONTAL DRIP PAN IF YOU INSTALL THE AIR
CONDITIONER HORIZONTALLY (FIG 2.2) ON THE TOP OF YOUR ENCLOSURE. FAILURE TO DO SO
MAY ALLOW CONDENSATE TO DRIP IN AN UNCONTROLLED MANNER CAUSING DAMAGE TO YOUR
EQUIPMENT.
APPLY POWER
Once the air conditioner is mounted, check the serial label and confirm the voltage required
and then apply appropriate power as outlined below.
120 VAC units – plug into standard 120 volt, grounded outlet. Amperage for a 120 VAC unit is
2.0 amps.
220 – 240 VAC units – this unit will not have a plug on the end. Connect the wires to an
appropriate power source using standard safe wiring methods. Wire colors are as follows:
Black or Brown – line
White or Blue – line/neutral
Green or Green/Yellow – ground
A wiring diagram is shown in Fig. 2.4 below.
Amperage for a 220 VAC unit is 1.4 amps.
Figure 2.4
