3) When installing DO NOT connect the mains power.
Once position has been selected
4) When fixing the mounting plate to the wall measure to the correct
distance between screw holes, 140 mm. Do not fully insert the screws
into the wall, leave the screw heads 2-3mm above the wall surface.
5) Mount the backing plate onto the protruding screw heads and mark
the hole for the final screw that secures the unit to the wall. Remove
unit and drill final hole and insert the wall plug.
6) Refit the unit on the screws and fix the bottom securing screw.
7) Replace the front cover, screws and screw caps.
Storage
When heater is not in use or during heavy whether conditions remove bottom
screw and lift heater off holding screw and store in original packaging in a dry
area.
OPERATING INSTRUCTIONS
The appliance is switched on and off using the pull switch (parts description
point 5). The slight vibration noticeable when the appliance is switched on will
stop after a few seconds.
- Position 0: OFF
- Position 1: 650W (Low heat) only 1 element will heat
- Position 2: 1350W (Medium heat) 2 elements will heat
- Position 3: 2000W (High heat) 3 elements will heat
MAINTENANCE
Warning: always remove the plug from the mains socket before moving or
servicing. Do not immerse your heater in water.
•
Before cleaning turn the heater off and unplug from the power
Supply. Allow the heater to cool down for a minimum of 15 minutes.
•
To clean the heater use a soft cloth to wipe off any dust. If the heater
is very dirty use a damp cloth to wipe the exterior casing and wipe
dry. Do not use any cleaning
detergents, sprays or other chemicals, as they will damage the heater.
•
Store the heater in the original packaging in a ventilated dry area.
SPECIFICATION
Power: 2000W
Voltage: 220-240V ~ 50Hz
Net weight: 1.65 kg
Gross weight: 2.1kg
