7
Important notes
Installation FaQs
Which parts have been delivered?
• Sash packet per stop diagram, complete,
with pre-installed hinge profile and espagno-
lette closure
• Shutter catch and stop angle per stop dia-
gram, supplied loose in package, with acces-
sories (supporting block and rivets)
Which means of attachment are being used?
• The fitting materials are not included in the
scope of delivery!
• The selection of the fitting materials is based
on the mounting bases on hand, the load-
bearing capacities of which are to be checked
before the installation. observe without limi-
tation the regulations of the manufacturers of
dowel and fitting materials.
WarNINg
Danger of injury/property damage
caused by unsuitable fitting materials
the fitting materials are to be selected
in accordance with the load-bearing ca-
pacity of the mounting bases.
Which parts are to be positioned where on
the structure?
• Sash packet with pre-installed hinge profile
on the on-site connection profile
• Shutter catch on the reveal
• Stop angle in the centre of the espagnolette
• Additional central stop angles for joint profiles
PE-G60/-G80/-G100
What must be observed during on-site per-
formance?
• The connection profile must be aligned per-
pendicularly on-site prior to installation.
• The customer is responsible for ensuring that
the sash packets are properly fastened to the
connection profile and that suitable fitting ma-
terials are used.
WarNINg
Danger of injury/property damage
caused by falling folding sliding sashes
Missing or incorrectly set locking parts
may result in the sash packets falling.
Secure the sash packets using the
shutter catches when open and the es-
pagnolette when closed.
CautIoN
risk of cutting injuries caused by the
sharp edges on the vertical profiles
Use gloves for the installation.
What is to be taken into account with the
function check?
• In the case of double-sided diagrams, do
the sash packets align in the middle when
closed?
• Is there a sufficient gap (10 mm) between the
frame edge and edge of the reveal to prevent
the screw heads from touching?
• Are the locking parts, espagnolette and shut-
ter catches installed in the correct manner?
