EHC DSR Smart Gateway, Инструкция по установке и эксплуатации, Страница: 10 / 28

3. Installation (cont.)
Control cabling – RF models
All Radio Frequency radiators come complete with a pre-wired receiver in T-RF which is
controlled by either the T-Pod
or T Basic Thermostat
.
9
. T-Pod installations
a
b
Follow the instructions outlined in section
7
for single radiator installations.
Locate the T-Pod programmer on a suitable wall in the same room as the radiator.
Configure the T-Pod programmer and receiver in T-RF located on the radiator.
According to the instructions included in the T-Pod packaging. Set the required
program times and temperatures.
1
0
. T-Basic installations
a
b
c
d
Follow the instructions outlined in section
7
for single radiator installations.
Locate the T-Basic digital room thermostat on a suitable wall in the same room as
the radiator.
Configure the T-Basic digital room thermostat and receiver in T-RF located on the
radiator according to the instructions included in the T-Basic packaging.
Set the required temperature by adjusting the +/- buttons.
1
1
. TDI Installations
a
b
Follow the instructions outlined in section
7
for single radiator installations
Configure the TDI Digital Control Display according to the instructions on
page
12 &
1
3 of this manual. Set the to set
the radiator setting the required
time and temperature.
CAUTION - After completion of works all electrical connections should be tested for
tightness.Additionally an electrical safety check should be carried out ie: short circuit,
earth continuity, resistance to earth and polarity check and all the relevant test
certificates produced
Installing castors and feet
1
2
. All radiators are supplied with wall mounting brackets, however with the exception of the
Towel Rail
& Tall heaters, optional
feet or castors
can be purchased.
Consult the
information
leaflet
that
comes with
castors or feet f
or fixing instructions.
Page 9