Ego Power+ ST1400E-ST, Руководство оператора

Страница: 8 / 228

56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1400E-ST
8
EN
5. Pull up the level of the lock pole so that you can
easily move/rotate the loop handle to where you feel
comfortable. then lock the lever of the locking pole.
(Fig. H).
WARNING:
The tool cannot be used without the
front handle securely fixed.
ADJUSTING THE REAR HANDLE
If the length of the shaft is not suitable for operation, you
can adjust the length of the shaft through this Height
Locking clamp.
1. Remove the battery pack from the trimmer.
2. To adjust the trimmer height, open the height locking
clamp, and then slide the shaft up or down to desired
height, securing it in place by depressing the locking
clamp (Fig. I).
NOTICE:
The front assist-handle may require to be
readjusted after the trimmer height is changed.
OPERATION
WARNING:
Always wear safety goggles or safety
glasses with side shield, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
You may use this product for the purposes listed below:
Trimming:
Used for removing grass and weeds up
against walls, fences, trees and borders.
Cutting:
Used for cutting the grass that is difficult to
reach using a normal mower.
ATTACHING/DETACHING THE BATTERY PACK
Use only with EGO’s battery packs and chargers listed in
Fig. A2.
Fully charge before first use.
To Attach
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a “click” (Fig. J1).
To Detach
Depress the battery-release button and pull the battery
pack out as Fig. J2 shown.
J-1 Battery- Release button
HOLDING THE LINE TRIMMER
Hold the line trimmer with both hands: One hand on the
rear handle and the other hand on the front-assist handle.
NOTICE:
The trimmer head is parallel to the ground at
a proper cutting distance without the operator bending
over (Fig. K).
STARTING/STOPPING THE LINE TRIMMER
To Start
Move the locking tongue forwards then depress the
switch trigger.
The trigger is stepless speed adjusting. The more you pull
up the trigger, the higher speed it is (Fig. L).
To Stop
Release the switch trigger.
SPEED ADJUSTMENT FUNCTION (FIG. L)
The line trimmer has two speeds. Position“LOW” is for
low speed while Position “HIGH” for high speed.
Fig. L parts description see below:
L-1 High/low-Speed Switch L-2 Switch Trigger
USING THE LINE TRIMMER
Clear the area to be cut before each use. Remove all
objects, such as rocks, broken glass, nails, wire, or line
that can be thrown or become entangled in the cutting
attachment. Clear the area of children, bystanders,
and pets. At a minimum, keep all children, bystanders
and pets at least 15m away; there still may be risk to
bystanders from thrown objects. Bystanders should be
encouraged to wear eye protection. If you are approached,
stop the motor and cutting attachment immediately.
Before each use, check for damage/worn parts
Check the bump head, guard and front-assist handle
and replace the parts that are cracked, warped, bent, or
damaged in any away.
The line-cutting blade on the edge of the guard can
dull over time. It is recommended that you periodically
sharpen it with a file or replace it with a new blade.
After each use, clean the trimmer.
ADJUSTING CUTTING LINE LENGTH
The trimmer head allows the operator to release more
cutting line without stopping the motor. As line becomes
frayed or worn, additional line can be released by lightly
tapping the trimmer head on the ground while operating
the trimmer (Fig. M).