Ego Power+ CS1610, Руководство оператора

Страница: 26 / 156

56V LITHIUM-ION CORDLESS CHAIN SAW — CS1610/CS1610-FC
26
3. Position the chain saw on its side
on a firm, flat surface, so that the
tank cap is facing upwards. Lift
up the semicircular tab. Grasp the
tab and rotate the oil-tank cap
counterclockwise to remove it
(Fig. 9).
4. Carefully pour the bar and chain oil
into the tank. Fill to the MAX line,
wipe off any excess oil.
5. Replace the cap. Make sure the oil-tank cap is tightly secured in place.
NOTICE:
◾
Never use oil or other lubricants not specifically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature wear of
the bar and chain.
◾
Check the oil level frequently and fill when the oil level falls below the minimum
line. Never operate the chain saw if the oil is not visible.
◾
Do not use dirty, used or otherwise contaminated oil. Damage may occur to the
bar or chain.
◾
It is normal for oil to seep from the saw when it is not in use. To prevent seepage,
empty the oil tank after each use, and then run the saw for one minute. When
storing the tool for a long period of time, be sure the chain is lightly lubricated.
This will prevent rust on the chain and bar sprocket.
◾
To preserve natural resources, please recycle or dispose of oil properly. Consult
your local waste authority for information regarding available recycling and
disposal options.
9
Oil Tank Cap
Max Line