Egholm 2001, Руководство оператора

Страница: 14 / 20

P Pe erriio od diic c//IIn n--d de ep ptth h c clle ea an niin ng g::
At the end of the season or when storing the spreader
for a longer period of time, corrosion prevention is
essential.
A) Complete all procedures listed under "Daily
cleaning".
B) Disassemble the front screen by removing the four
bolts located at the bottom. Then simply pull off the
screen. Clean the underlying parts thoroughly with
water and dry them with a cloth. Finally, smear the
parts with a rust-preventing fluid.
C) Grease the bearings.
Only grease the large bearing if the stirrer system is
not assembled. Also grease both of the joints if the
stirrer system is assembled.
D) Smear all parts of the spreader with rust-preventing
fluid - in time, even stainless steel can corrode.
E) Wearing parts such as the feed screw are not
made of stainless steel. Therefore, please pay extra
attention to them when cleaning and applying rust
preventive.
F) Make sure to remove all salt residue etc. from the
roller stand.
G) As part of this procedure, make sure to check all
nuts and bolts and tighten them if required.
Bolts
Lubrication nipple
14
3. SERVICE AND MAINTENANCE
1
2