Egcon GCU-DG3, Руководство пользователя

Страница: 21 / 25

GCU -DG3 User's Guide
EGCON Co,. Ltd
21 Page
16.8. SENSOR SELECT
NO. Menu Explanation Setting Scope Default
1 OP MODEL Selection of oil pressure sensor VDO VDO
2 WT MODEL Selection of water temperature sensor VDO, DONGNAM DONGNAM
3 OT MODEL Selection of oil temperature sensor VDO, DONGNAM DONGNAM
4 OP CALIB
l
Revision of oil pressure sensor value
l
Value revision when using VDO sensor: unit
is 0.3bar
-4.0 ~ 4.0bar 0.0bar
5 WT CALIB
l
Revision of water temperature sensor value
l
Value revision when using VDO sensor: unit
is 3‘C
l
Value revision when using DONGNAM
sensor: unit is 5‘C
-40 ~ 40℃ 0.0℃
16.9. PROTECT SETTING
NO. Menu Detection Setting Value Default
1 BASE
Overspeed, over oil, over
temperature, start failure,
overvoltage
GEN RUN, GEN STOP
(주3 참고)
GEN STOP
2 UVR Detection of low-voltage GEN RUN, GEN STOP GEN RUN
3 OCR Detection of over-current GEN RUN, GEN STOP GEN RUN
4 OCGR Detection of over-current GEN RUN, GEN STOP GEN RUN
5 AFR
Detection of preliminary
fault input
GEN RUN, GEN STOP GEN RUN
6 CURR UN
Detection of current
unbalance
USED , NONUSE USED
16.10. ACB & ATS MODE SET
NO. Menu Setting Scope Default
1 ACB & ATS MODE SET ACB , ATS , NONUSE , MCCB TRIP ACB
16.11. RS485 SET
NO. Menu Setting Scope Default
1 ADDRESS Setting of communication address (1 ~ 16) 1
2 BAUD RATE 9600bps 9600bps
3 RS485 CK
No : RS485 TEST nonuse
YES : RS485 TEST on - LCD indicate
NO