9
Chapter 3
TX3000Cable\Opto Synchronization Setting
3.1. TX3000 cable
synchronization setting
On the TX3000 are two optional Wire Cable Sockets,one is Cable In and the other is
Cable Out.
3.1.1. TX3000 cable synchronization
output setting
(
master)
•
J15 must be 2-3 IN
•
must be connect by twisted-pair
The system can provide two sets of cable out.On the board of TX3000,it is annotated as
X4(Cab Out), N0. 1 and 2 of X4 is the first group ,and N0. 3 and 4 is the second
group.The setting of one group sync output is same to the two groups sync output(refer to
the above).Each cable out should connect to the corresponding sockets. E.g. If you use the
first group of cable ,you should connect to the N0.1 and 2 sockets of X4
（
refer to the
figure of TX layout 1).
