If you choose
not
to use the piston, please follow these instruc-
tions carefully:
1.
While holding the barrel upright in one hand, twist on an
orange tip cap. Using the small funnel supplied, fill about
2/3 full with your liquid.
2.
Open the safety clip and attach the barrel to the 10cc adapter.
3.
Close the safety clip as tight as possible.
4.
Increase vacuum by turning vacuum control knob counter-
clockwise and set to 1.5 on the vacuum pressure gauge.
5.
Then, without tipping the barrel upside down, remove the tip
cap and attach the 25 gage (red) tip.
6.
Open the safety clip. Your material may begin to bubble.
Reduce vacuum by turning vacuum control knob clockwise.
7.
If a drop begins to form at the end of the tip, slowly turn the
vacuum control knob counterclockwise to stop the drop from
growing. Wipe the tip and adjust vacuum as necessary.
Now the fluid is in proper balance. It does not bubble or drip.
Repeat tests as before, keeping the air pressure low and adjust-
ing the time for different deposit sizes. Contact EFD if you have
any questions.
In the US, call 800-556-3484.
In Mexico, call 001-800-556-3484.
In the UK, ring free 0800 585733.
☎
Do not tip the barrel upside down
or lay flat. This will cause the
liquid to run into the dispenser.
When changing tips
or attaching a tip cap,
snap the safety clip
completely closed to
prevent any dripping
or bubbling.
Three things to remember
If you do not use the piston when
dispensing thin fluids:
Use an EFD filter trap (#1000FLT-Y).
This filter trap will impede the flow
should the low viscosity liquid be
sucked back towards the dispenser.
Open
Closed