Efco SWAPLOADER SL-185, Руководство по эксплуатации и частям

Страница: 85 / 109

SL-185.MAI
4-11
11/2010
PRESSURE CHECK INSTRUCTIONS
When performing a pressure check on a SwapLoader hook-lift hoist, we recommend that you use
a calibrated pressure gauge that reads pressures up to 3,500 PSI (a 0 to 5,000 PSI range gauge is
recommended). As a minimum, the gauge should have 100 PSI graduation marks (50 PSI is
preferred), and a 3 inch diameter dial size (4 inch dial is preferred). The pressure gauge should
be outfitted with a female JIC #4 hydraulic adapter; preferably located at the end of a 3/8 inch
diameter high pressure hydraulic hose that is 2 to 3 foot in length (see illustration below).
Should you not be able to source a hydraulic gauge locally, SwapLoader can provide one at a
reasonable cost (Hyd. Pressure Gauge & Hose Ass’y – Part No. 22P10).
PRESSURE CHECK STEPS
1. Locate the 90
°
male JIC #4 hydraulic adapter (SWL #10P37) found on the top of the
hoist hydraulic control valve (see illustration below).
This 90
°
male #4 JIC hydraulic adapter is supplied by SwapLoader, and should be
installed in the hydraulic control valve at the time of the hoist installation (see the hoist
parts & operations manual).
SWL P/N: 10P37
Hydraulic Adapter
SWL P/N: 10P38
Hydraulic Adapter
Hyd Control Valve Ass'y
MP/MJIC 90° (-4-4) FMJIC Cap (-4)
Hyd. Tubing Ass'y
(to rear of hoist)
Hyd. Hose Ass'y
(to front of hoist)
PRESSURE CHECK HYDRAULIC ADAPTER LOCATION ILLUSTRATION
RECOMMENDED PRESSURE GAUGE ILLUSTRATION
500
1000
1500
2000
2500
4000
3500
3000
4500
5000
Pressure Gauge (recommended)
Hydraulic Adapter
FMJIC Swivel (-4)
Hydraulic Hose Assembly
High Pressure 3/8 Dia.
2' to 3' in length
0
0 to 5,000 PSI Range
4" Dia. Dial Size
50 PSI Graduation Marks