en
29
Bevel Gear
Fill with grease using the correct tube to the
level of the lower lip of the access hole (D,
Fig. 8). Do not use more than 0.02 lb (10
grams).
CAUTION: do not use a grease
g u n . T h e h i g h p r e s s u r e c a n
damage the bearings and seals.
Use high quality molybdenum bisulphide
grease.
Guard
WARNING: If the cutting tool or
deflector becomes clogged or
stuck, always turn off the engine
and make sure the cutting tool has
stopped before cleaning. Grass,
weeds, etc. should be cleaned
off the cutting tool at regular
intervals.
Replace guard if damaged.
Use only resistor type spark plugs of the
approved range.
Factors such as:
- too much oil in fuel mix;
- dirty air fi lter;
- unfavourable running conditions, e.g.
operating at part load;
may result in rapid deterioration of the spark
plug.
Muffl er
WARNING! – This muffl er is fi tted
with a catalytic converter needed
for the engine to be in compliance
with the emissions requirements.
Never modify or remove the
catalytic converter: failure to do
so is a violation of law.
WARNING! – Muffl ers fi tted with
catalytic converters get very hot
during use and remain so for
some time after stopping. This
also applies at idle speed. Contact
can result in burns to the skin.
Remember the risk of fi re!
WARNING: Do not operate your
brush cutter if the muffler is
damaged, missing or modified.
An improperly maintained
muffl er will increase the risk of fi re
and hearing loss.
MAINTENANCE