Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
7
SC WK 232 - 081209
Assembly page 7/7
Fax +32 2 359 95 50
BEFORE THE FIRST OPERATION
Before the first use or after descaling, it is necessary to operate the jug kettle with fresh water in
order to clean any residue left from the manufacturing process. To do so, turn the temperature
knob to its MAX position and press the switch situated near the handle. When the boiling
process is over, pour the water. Repeat the process 3 times with fresh water. Then rinse with
cold water.
USE
With this appliance you can boil water or you can heat it up to a certain temperature, for
example till 80°C for special teas.
Boiling
: to boil water, use the switches "0" and "I" on the handle. Turn the temperature knob to
the MAX position. Fill the jug with the desired amount of water, making sure that the water level
is between the minimum and maximum indication of the level indicator. Press switch "I". The
pilot light goes on, indicating that the appliance is operating. After the boiling process, a
steam switch automatically switches off the appliance. The pilot light goes out.
Caution
: a steam switch situated on the handle allows automatic switch-off. Steam can
condensate and some water could escape from the handle.
Heating
: you can set the desired temperature with the temperature knob. In order to reach the
desired temperature, it is necessary to pour at least 1 litre of water in the jug. The generally
used switch-off temperature is 80°C. Press the switch "1" at the level of the steam switch on the
upper part of the handle. The water will heat up and the jug kettle will switch off automatically
when the desired temperature is reached. If the water cools down to a temperature lower
than the set temperature, the appliance starts heating again.
Switch off the appliance after having heated water by pressing the switch "0" on the handle.
The pilot light goes out, indicating that the appliance is switched off.
Caution
: if you do not switch off the appliance, it will keep operating until the water in the jug
kettle has completely evaporated. When this happens, the overheat protection will be
activated. Hint: let the appliance cool down for 10 minutes before filling it anew.
SAFETY CUT-OUT
•
This jug kettle is protected with an automatic safety device if accidentally switched on
without water. Please bear in mind that only the thermostat is switched off in case of
overheat, whereas the switch stays in ON-position.
•
In this case, switch off the appliance by putting the switches in "0" and "MIN" position and
wait about 10 minutes for the element to cool. Then pour in sufficient cold water to cover
the element.
•
The kettle may then be used as normal.
CLEANING AND MAINTENANCE
•
Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
•
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
Never use abrasive products
•
On no account must the jug kettle or its power base be immersed in water.
All manuals and user guides at all-guides.com
