Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
7
SC GR 900 – 111010
Assembly page 7/16
Fax +32 2 359 95 50
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp
plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour
coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
BEFORE FIRST USE
Clean the grill and the accessories (cf. CARE AND CLEANING). It is recommended to heat up
the barbecue grill for about 10 minutes without any foodstuff in order to eliminate the grease
that may have adhered during manufacture and the “new” smell.
OPERATION
•
Place the water basin (5) into the grill casing. The 4 notches on the edge snap into the
plastic housing. Fill the grill tub with cold water (maximal amount: 1 litre).
•
Insert the holder and regulator part of the heating element into the notch at the top of the
grill tub until the heating element locks precisely in place in the housing.
•
Put the grill rack (3) on the heating element.
•
Attach the windshield (4) slantwise from behind.
•
The water in the grill tub will evaporate during use. It is therefore necessary to refill water
from time to time. Do not spill water on the heating element, as this could be dangerous.
Use the water refill opening (2).
•
Connect the appliance and switch it on using the thermostat knob (8) (turn clockwise). The
red pilot light (6) will light up to indicate that the appliance has been switched on.
•
Preheat the grill for about 5 minutes with maximum power and then select the cooking
temperature using the thermostat knob.
•
During cooking, the red pilot light will come on and off regularly. This simply means that the
thermostat is regulating the appliance's temperature.
•
Now put the foodstuffs onto the grill rack.
•
The grilling times vary according to the nature of the foodstuffs and to your personal taste.
•
When grilling is finished, turn the thermostat knob to its minimum position and disconnect
the appliance.
PRACTICAL HINTS
•
Frozen food should always be thawed before it is grilled.
•
From time to time check the water level in the water basin (5).
CARE AND CLEANING
•
Before cleaning any domestic electrical appliance, always make sure that the plug has
been removed from the mains supply socket.
•
Allow the grill to cool down thoroughly before cleaning.
•
Take off the grill rack.
•
Take off the holder and regulator part with the heating element.
•
Now you can take out the water basin as well. Pour out the remaining water.