instructions
uct connection adapter to outlet of cooling air (Insert the bottom
D
Assemble
Process:
edge of adapter into the hooks on the front side of inlet of evaporator, then screw
in the screws.
→
Twist the air duct pipes into duct connection adapter
→
Adjust the length
and direction of pipes.
This accessory can be used in some environments, such as the cab, RV, where it is not
convenient to place the Mate 2 for cold air reaching the position you want.
After installation, hold the adapter with one hand when pulling the air duct to the desired
position.
USE ENVIRONMENT
Your installation location should meet the following requirements:
⚫
Make sure that you install your air conditioner on an even surface to minimize noise
and vibration.
⚫
If using with a power adapter, the device must be put near a grounded plug.
⚫
When the device is working and the air duct is not connected, make sure that there is
no obstruction in the exhaust air inlet and outlet at least 100cm, and there is no
obstruction in the front supply air and inlet at least 30cm.
