GENERAL SAFETY
The “Eemax ProAdvantage” heater is specifically designed to take in cold or hot water and
heat it up to a maximum of 140F (60C). To obtain optimum performance and energy savings,
the unit should be located as near as possible to the point of use. The unit is supplied with
1/2” compression fittings.
THIS UNIT HAS ONE
DEDICATED INDEPENDENT 120V, 208V,240V
OR
277V
CIRCUIT. USE CORRECTLY RATED WIRES AND CIRCUIT BREAKERS.
U.L. 499, 18.4. THE RATING OF THE BRANCH-CIRCUIT OVERCURRENT
PROTECTIVE DEVICE SHALL BE 150% OF THE RATING OF THE PRODUCT.
DO NOT USE SPACE SAVING BREAKERS
.
WARNING
IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE, OR MAINTENANCE,
MAY CAUSE
DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE
. REFER TO
THIS MANUAL FOR ASSISTANCE OR CONSULT THE LOCAL ELECTRIC UTILITY FOR
FURTHER INFORMATION.
FAILURE TO
GROUND
THE SYSTEM MAY RESULT IN DEATH OR SERIOUS INJURY.
WARNING
WARNING
WATER HEATERS ARE EQUIPPED FOR ONE VOLTAGE ONLY:
THIS WATER HEATER IS
EQUIPPED FOR THE VOLTAGE DISPLAYED ON THE MODEL RATING PLATE. DO NOT
USE THIS WATER HEATER WITH ANY OTHER VOLTAGE OTHER THAN THE ONE
SHOWN ON THE MODEL RATING PLATE. FAILURE TO COMPLY WITH THIS MAY RESULT
IN DEATH, SERIOUS BODILY INJURY, AND/OR PROPERTY DAMAGE. IF YOU HAVE ANY
QUESTIONS OR DOUBTS CONSULT EEMAX OR YOUR LOCAL ELECTRIC COMPANY.
WARNING
HAZARD OF ELECTRICAL SHOCK!
BEFORE REMOVING THE COVER OR SERVICING THE
WATER HEATER, MAKE SURE ALL ELECTRICAL SOURCES TO THE WATER HEATER ARE
TURNED “OFF”. FAILURE TO DO THIS MAY RESULT IN
DEATH, SERIOUS BODILY INJURY,
OR PROPERTY DAMAGE
.
NOTE: THIS UNIT HAS ONE DEDICATED INDEPENDENT ELECTRICAL POWER
CIRCUIT CONNECTION.
2
DISCONNECT THE POWER CIRCUIT BEFORE SERVICING.
DO NOT SOLDER PIPES WHILE THE UNIT IS INSTALLED
(serious damage to the electronic flow switch will result).
