EemaX HotMAx HM013240, Инструкция по установке и руководство пользователя

Страница: 5 / 16

5
Alternatively, you may install an active water leak detector and shutoff valve designed to turn off your water
supply in the event that a leak is ever detected.
3- MOUNTING YOUR WATER HEATER
Your HotMax should be secured to the mounting surface with 4 screws
(minimum 1” (25.4mm) long) using the built-in mounting holes on the back
side of the heater (Figure 1). If using a pre-existing dispenser location, make
sure the heater is mounted within 20” of the dispenser fittings.
Make sure
that the mounting surface is solid and secure, and ensure that the unit is
level prior to securing the screws.
For maximum function and servicing, we
recommend that this product be installed in an upright position with the inlet
and outlet water connections at the top of the unit. Water connections
should be easily accessible under the sink so that the dispenser can be
secured and tightened to the heater.
Recommended Clearances for Safety and Service Maintence:

4” (101.6 mm) above

9” (228.6 mm) below

6” (152.4mm) in front and to the sides
DANGER Flammable materials should be kept at least 24” (609.6mm)
away from your water heater and the hot water outlet pipe.
Mounting Steps:

SHUT OFF ELECTRICITY ON YOUR CIRCUIT BREAKER BEFORE PROCEEDING TO ANY FURTHER
INSTALLATION STEPS.

Make sure there is an inlet water line that can supply 0.4 gpm to
0.6 gpm of continuous water flow to HotMax.

Close the water supply valve on the inlet water line before
installation.

Clear out any obstructions or possible hazards from under the sink
before installation.

Using the mounting template inside the packaging, select a
location for HotMax. Be sure to leave the proper clearances on all
sides according to the template.
Figure 1