HD490 AFD Software
3.2.6
Add Code Swap Rules
The code swap rules tool enables dynamic mapping from one AFD code
at the input to another at the output. This feature is useful in situations
where other equipment has automatically stamped the video signal with
undesirable AFD codes, or for any situation in which problematic AFD
codes arrive on the signal. If there is no code swap rule specified for
a code, the default behavior is to show the code on the output signal
whenever it appears on the input signal.
To select the incoming AFD code to be switched, use the drop down list
located underneath the Incoming Code label and click on the desired
code. Then, use the drop down list located underneath the Switch To
label to select the AFD code you would like the incoming code to be
switched to. Click on the
Add
button to the right of the two drop down
lists to add the code swap rule.
Once a code swap rule has been added, it appears in the table labeled
Existing Rules, where the Incoming and Outgoing codes are listed next
to each other, followed by a
Remove
button. To delete a code swap rule,
go to the line in the table where the swap rule is and click the
Remove
button to the right of the code swap rule.
Copyright © EEG Enterprises, Inc. 2009-2011
9
