EDX Mag Drill EM16, Руководство пользователя

Страница: 12 / 18

12
CAUTION: To avoid damage to the tap or machine, be very
careful to stop the machine in time to NOT allow the tap
bottom out. The motor continues to coast for a while
after being shut off, so plan for this and anticipate.
This machine does NOT have a clutch.
CAUTION: To avoid damage to the machine, ALWAYS allow the machine to come to a full stop
before reversing rotation.
1. Select the proper speed according to the chart for the size of tap used.
2. Begin with forward direction of rotation with standard right hand threads.
(Opposite with left-hand threads)
3. Allow the tap to determine the feed rate. A light touch on the feed handle is all that is
needed once it is started in the hole.
4. When the desired thread is tapped, hit the red motor stop switch. Allow the machine to
come to a full stop. Then reverse direction and restart machine by pressing the green motor
switch to remove tap. Guide the tap back out with the feed handle. Proper order of
operations for normal tapping is as follows: magnet: on. direction: forward. motor: on. motor:
off. THEN: direction: reverse. motor: on. motor: off - magnet: off.
MAINTENANCE
1. Keep the machine clean and free of chips.
2. Check for loose fittings and tighten as needed.
3. Ensure that the ventilation slots are clear so that motor can be cooled normally. Blow
low-pressure compressed air through the ventilation slots with the motor running to keep
motor clean.
THE ARBOR SHAFT
Keep the arbor shaft free of dirt and lightly grease as needed. If the arbor support bearing is
noisy, it may be dirty or have a chip lodged in it. Remove the arbor shaft to clean and
re-grease the arbor support bearing.
PORTABLE MAGNETIC CORE DRILLING SYSTEM