Edwards nEXT 55, Инструкция по эксплуатации

Страница: 65 / 116

To set a vent option on auxiliary output 1, send the command that follows (character 'd'
refers to the option number shown in Table: Vent valve options ):
Command ! S 8 5 3 sp d cr
The reply is as follows:
Reply * S 8 5 3 sp r cr
The venting option is now stored in the memory of the pump.
To check what venting option is set, send a query that follows:
Command ? S 8 5 3 cr
The reply is as follows:
Reply = S 8 5 3 sp d cr
To set the valve type on auxiliary output 1, send the command that follows (character 'd'
refers to the option number shown in Table: Valve types ):
Reply ! S 8 7 7 sp d cr
The reply is as follows:
Reply * S 8 7 7 sp d cr
The valve type is now stored in the memory of the pump, but a power cycle is necessary
before the auxiliary 1 output circuit adjusts to the stored request.
To check what venting option is set, send a query as follows:
Reply ? S 8 7 7 cr
The reply is as follows:
Reply = S 8 7 7 sp d cr
5.1.6 Standby speed setting
You can operate the pump at a standby speed rather than full rotational speed. The
standby speed is a user-configurable option and can be set to the value between 55%
and 100% full rotational speed. When the pump is shipped, it is configured with a
standby speed of 70% full rotational speed.
To change the standby speed setting, use one of the methods that follows:
▪ Use the STDBY+ and STDBY- push buttons (given on the motor controller). Each
push of the button adjusts the speed by 15 Hz (1%). Refer to Figure: Motor
controller status information .
▪ Use a serial command
To change the standby speed setting using a serial command, send the command that
follows (characters 'd' shows the value as a percentage of full rotational speed):
Command ! S 8 5 7 sp d d d cr
The reply is as follows:
Reply * S 8 5 7 sp r cr
07/2021 - ©Edwards Limited Page 65 B8G000880_E
B8G000880_E - Configuration