© Edwards Limited 2008. All rights reserved.
Page 7
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
A462-26-880 Issue F
3
Installation
3.1
Unpack and inspect
Remove all packing materials and check your EMF Oil Mist Filter. If your filter is damaged, notify your supplier and
the carrier in writing within three days; state the Item Number of the filter together with your order number and
your suppliers invoice number. Retain all packing materials for inspection. Do not use the filter if it is damaged.
Check that your package contains the items shown in
Table 1
. If any of these items is missing, notify your supplier in
writing within three days.
If the filter is not to be used immediately, return it to its protective packaging and store in suitable conditions: see
Section 6
.
3.2
Install the EMF filter
3.2.1
Install the EMF filter on Speedivac 2 pumps
Note:
You can directly fit the EMF3 Oil Mist Filter to current models of the Speedivac 2 pump; however on early
models (with Serial Numbers less than 26977), you will need to use two NW10 elbows (with the appropriate
seals and clamps) to fit the filter.
You must install the EMF filter vertically with the direction of exhaust flow as indicated by the arrow on the lower
part of the body. Use the following procedure to fit the EMF filter:
1. Remove the oil filler plug and the O-ring from the top of the oil box.
2. Remove the outlet nozzle and the Dowty washer from the adaptor, and replace them with the filler plug and
O-ring removed from the oil box.
3. Fit the 3/8 inch BSP to NW10 adaptor with Dowty seal (supplied with the EMF filter) into the 3/8 inch threaded
hole in the top of the oil box.
4. Use the O-ring and clamping ring supplied to fit the EMF filter to the adaptor.
Table 1 - Checklist of items
Qty
Description
Check (
9
)
1
EMF Oil Mist Filter
1
Adaptor
1
Centring-ring and O-ring
1
Clamping ring
1
O-ring seal