Edwards D397-01-000, Инструкция по эксплуатации

Страница: 45 / 56

© Edwards Limited 2016. All rights reserved. Page 37
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation
D397-01-880 Issue E
4.14 Relay setpoint outputs
The relay setpoints option allows the setpoint outputs on the logic interface to be linked to a gauge pressure. They
are set up in the same way as Linking Gauges, refer to
Section 4.11 .
When a relay setpoint becomes active, the display section on the view screen will change to reverse video.
4.15 Service information
Service information contains the following information:

Software Issue - This is the issue of the currently installed software. This will change when new software is
downloaded to the TIC in the future.

Serial Number - The Serial number of the TIC is used when contacting Edwards about the product.

Analogue O/P - The analogue output value (internal units) is used when contacting Edwards about the
product.

Reset TIC - Resets the TIC to its factory default configuration and can be used to quickly undo all user
settings (links between gauges and pumps, relay setpoints, units, gauge gas types, etc).
4.16 Electrical supply failure
If the electrical supply to the TIC fails, any gauges connected and the logic interface will stop operating until the
power is restored.