Edwards & Co Ed & Co multi-fix PA0101, Инструкция по эксплуатации

Страница: 10 / 14

Installing the base using seat belts
Open the base stand by pressing the stand release button and moving
the locking clip from position 2 to 1 as shown in Figure (2) on page 8.
1. Thread the lap belt and
shoulder belt of your vehicle’s
3-point seat belt through
the seat belt guide stickers
found on the base (as shown
in Figure (1) and connect the
buckle as shown in Figure (2).
2. Put your weight down onto the
base and pull the seat belts
as tight as you physically can,
then attach the belt-lock as
shown in Figure (2). The belt-
lock should always be on the
same side of the base as the
car buckle. Note - if you find
the seat belt buckle is too long,
you can twist it up to three
times to shorten it.
3. If you car is fitted with an
Automatic Locking Retractor
(ALR), pull the shoulder belt
all the way out, then slowly
release it until you hear a
clicking/racheting sound.
Release it until the belt is tight.
10
designed in NZ
IMPORTANT
- make sure the lap belt and shoulder belt are tightly
wrapped around the seat before use. We suggest a few attempts to
get it as tight as possible.
IMPORTANT
- for vehicles with leather seats we recommend the use
of a rubber mat to reduce movement of the base.
WARNING
- the belt should be flat against the frame of the base. If
belt is crimped or twisted, reinstall the base.
1
2