LST10
LST11
Hollow Threaded
Heater
Hollow
Heater
LST10 / LST11
LONER
®
24V, 50W Soldering Instrument
3 oz (85 g)
made
in
U S A
LST11
1.
MAKE SURE YOUR TOOL IS COOL!
2.
Turn
RS372
counter-clockwise to remove.
3.
Remove old Soldering Tip.
4.
Insert new Tip.
5.
Install RS372.
soldering tip
RS372
Soldering Tip
ESD Safe
CHANGING TIP
LST10
1.
MAKE SURE YOUR TOOL IS COOL!
2.
Using a
TW318
or
WT620
(optional)Tip Wrench, turn
HC273
counter-clockwise to remove.
3.
For Threaded Tips, just screw the
Tip to the heater.
WT620
TIP CARE
1. Plugged-in Tool to 24V
temperature controlled
Power
Supply & set to desired temperature.
2. TIN the Tip (apply solder) before soldering.
3. Do not rub, bend or file Tip.
4. Always clean the Tip by wiping it against the saturated
sponge.
5. Always RE-TIN the Tip before and after using.
BASIC SOLDERING
1.
Allow Tool to heat up.
2.
Pre-heat the area to be soldered. Approximately 2
sec. for component leads.
3.
With the Tip still in contact with the working area,
apply solder on the working area.
(for solder, ask for
SS652
or
SS653
)
4.
Always clean the Tip by wiping it against the edge of
the moist sponge and re-tin.
DESOLDERING
1.
Melt solder in the area you want to
desolder.
2.
While keeping the solder in a molten state,
use a Desoldering Tool ,
EDSYN®
SOLDAPULLT®
to extract the molten solder.
for "-1"
for "-2"
Connector
TW318
soldering tip
HC273
install
remove
