Edsal UR-185PBB, Инструкция по сборке

Страница: 2 / 4

Figure F
Assemble two (2) post with one (1) brace. Skipping one slot
from the bottom of the post (see figure A), place the rivets
into post with the narrow end of the slots pointing down, and
with the shelf ledge of the brace facing up (see figure B). Tap
lightly on the top edge of the brace to seat rivets. Repeat with
two (2) post and one (1) brace. Next assemble the two (2)
post units with two (2) beams, skipping one slot from the bot-
tom of the post (see figure C). Place the rivets into post with
the narrow end of the slots pointing down, and with the shelf
ledge of the brace facing up (see figure B). Tap lightly on the
top edge of the beam to seat rivets.
Assembly Instructions UR - 185PBB, UR - 4818PBB & UR - 245PBB
Step
1
Figure C
Brace
Post
Beams
Figure C
IMPORTANT NOTE : Make sure all rivets are fully seated into the post
Start by adding a wood shelf to the level previously built,
then continue working by adding the second level using
two (2) beams and two (2) braces to the post slots of
your desired location. Again, place the rivets of the
beams and braces into the post slots with the shelf
ledge facing up and tap lightly to seat the rivets.
Step
2
Wood Shelf
Figure A
Tap lightly
to seat
rivets
Posts are
directional.
The narrow
end of the
slots must
point down.
Brace/Beam
ledge
Rivets
Figure B
Add a wood shelf to the previously built level, then assem-
ble four (4) posts to the four bottom post assemblies by us-
ing four (4) of the post couplers. Place the post coupler into
the top of the bottom post assembly and tap down to
properly seat. Next place a post into the top of the post cou-
pler and tap down to properly seat (see figure D). Continue
by adding the third level using two (2) beams and two (2)
braces just above the post couplers. Again tap lightly to seat
the rivets.
Step
3
Wood Shelf
Note: Posts are directional.
The narrow end of the slots
must point down.
Figure D
Bottom
Post
Top
Post
Post
Coupler
Add a wood shelf to the previously built level, then
continue by adding the fourth and fifth level to the unit
using two (2) beams and two (2) braces per level. Tap
lightly to properly seat the rivets and add the final wood
shelves to the unit (see figure E). Finally place the four
(4) post caps on the top of each post (see figure F).
Step
4
Figure E