10.
Do not insert any metal objects into the machine. Please do not grasp inside the
machine with your fingers.
11.
The laminating machine is unsuitable for constant use commercially. It is recommended
to switch “O” the machine for 30 minutes, after it has been operating for a period of
approximately 30 minutes.
12.
The socket should be near the device and easily accessible.
Starting up the laminating machine
1.
Push the plug into the mains socket outlet and set the switch to ‘I’. The red LED (Power)
lights up and the heating process will begin.
2.
The green LED (Ready) lights up after approximately 3 - 5 minutes. Now you can begin
the laminating process.
3.
Open the laminating film and lay the material that is to be laminated directly onto the
closed side. Leave a margin of between 3 mm and 5 mm approximately beyond the
edges while doing so.
Caution
a)
Choose a film of correspondingly suitable size in relation to the material that is to be
laminated respectively.
b)
It is not recommended to process several smaller materials in one film.
c)
Do not cut up the film before the laminating is done.
d)
The material that is to be laminated, is not allowed to be thicker than 0.5 mm
including the film.
e)
It is imperative to only laminate very thin or soft materials, like newspaper or
serviettes for example, with thicker films (100 microns). We recommend refraining
from any attempt to do so!
f)
Do not insert any laminating film without the contents.
g)
Never utilize laminating pockets on one side or when they are rolled up.
h)
Only utilize laminating foils that are also described as such. Other kinds of film, like
transparent wallets for example, are unsuitable for laminating!
4.
Insert the material within the laminating film straight and with the closed side first into
the feed opening on the machine’s front side. The material will feed it in automatically
now.
5.
The laminated material that emerges from the delivery opening on the machine’s back
side is not allowed to be pulled out by force. Wait until it has run out of the machine
completely. Let the laminated material to cool down briefly!
6.
Switch off the machine after the laminating has ended, by setting the switch to ‘O’. Let
the machine cool down and always pull the plug out of the mains socket outlet after
using the machine.
Note: Do not feed the laminator further with foil in case of a blockage. Turn off the device
immediately!
