End of Programming Mode
Press the mode key several times until "END" is shown on the display.
Press the "OK" key to end the programming mode. The display now indicates the
function ´Prog´.
Example:
When the device is switched on, the display shows which mode (Mod) is adjusted. If „Mod C“ is not
yet adjusted, change it as described on page 8.
1. Step:
How to define programs
In each ‘program’ speed and time are defined. Maximum 10 ‘programs’ can be stored. Out of these 10
programs a ‘program flow’ (or ramp) can be defined.
Press
key
▲
or
▼
until „PROG“ appears on the display.
The number of the program is shown at the upper right side.
PO
Confirm program No. „P0“ with the OK key.
The speed appears on the display.
✴
Edmund Bühler GmbH ALLGEM\BED.SMG/BEDSME/TXTE.DOC – 01/08
14
Turn the control knob to the right to adjust the required speed,
e.g.200.
Change to running time with key
▲
or
▼
. Adjust with the control knob,
e.g.
35
seconds.
0
Press
key
▲
or
▼
until „END“ appears on the display.
Store the values of „P0“ by pressing the OK key.
Select the next program (P1) with the control knob.
Confirm
with
OK.
flashes
flashes
flashes
✴
✴
✴
END
Min/S
1/min
Prog
PO
35
PO
PO
200
Set the values for P1 as described above.
flashes
